Reamers are designed to size an existing hole in most ferrous and non ferrous metals while producing an acceptable finish. The square on the end of the shank accommodates the tap wrench.
Reamers are designed to size an existing hole in most ferrous and non-ferrous metals, while producing an acceptable finish. The taper shank allows the tool to fit any arbor with the corresponding taper.
Reamers are designed to size an existing hole in most ferrous and non-ferrous metals, while producing an acceptable finish. The parallel shank allows the tool to fit any conventional 3 or 4 jaw chuck. (Sometimes referred to as a straight shank chucking reamer).
Carbon and High Speed Countersink Bits.
Using a Screwsink and Plug Cutter in combination with each other allows the user to hide a screw head by sinking the screw below the surface of the piece of wood and then by cutting a plug (for an accurate grain match always use an offcut of the same piece of timber) to place on top of the screw head to hide it. To ensure an accurate fit we suggest that you always use plug cutters and screwsinks from the same range as there are slight differences between manufacturers. The sizes represent the size of the Screw heads required to be sunk and are NOT metric or imperial sizes The sizes represent the size of the Screw heads required to be sunk and are NOT metric or imperial sizes.
Vitrex only £8.05
Vitrex only £4.49
Faithfull only From £7.66